Black Jack Roof Felt Adhesive Instructions
- Black Jack Roof Felt Adhesive Instructions Home Depot
- Black Jack Roof Felt Adhesive Instructions Mounting
- Black Jack Roof Felt Adhesive Instructions Vinyl
- Black Jack Roof Felt Adhesive Instructions Printable
Stick down loose felt etc with BLACK JACK ROOF FELT ADHESIVE. Blisters in roofing felt must be cut, dried, re-bonded and sealed. New metal surfaces must be degreased with a suitable solvent. Remove all rust or treat rusty surfaces with a rust inhibitive primer (eg zinc phosphate based). All non-bituminous, porous or friable surfaces must. How do I clean up a spilled Black Jack product? Consult SDS data sheets for the specific products. How soon can I coat a newly installed built-up roof with an aluminum roof coating? New asphalt built-up roof (BUR) surfaces should weather a minimum of 90 to 180 days prior to coating with Black Jack aluminum roof coatings. Apply 2 coats of Black Jack roof coating with a brush, allowing the first coat to dry before the second. Applying To Built Up Felt Roofs; First, remove loose chippings. If there are any defects wider than 0.75mm, fill in first with Bitumen Mastic and allow to dry. Any blisters should be opened and cleaned. Apply Black Jack and leave it to go. Black Jack Roof Felt Adhesive should be brush or mop applied to the surface and left “open” for 15 to 30 minutes before the roofing felt is placed into the wet adhesive film carefully, rubbing or rolling each section down to ensure maximum contact with the adhesive and ensuring that all air has been excluded.
I'm putting up a shed this week. In the past I've nailed the roofing felt to the roof as recommended and instructed in the manual.Clearly this creates entry points into the timber (the timber is usually OSB which is glue on wood - so I suppose the glue will probably stop damp from setting in.
In any case I decided to set it up so the roof lasts a bit longer.
Was curious if I need to use the glue AND reinforce with pins or is glue alone sufficient?
Again, it will be roofing felt on OSB which comprises of wood AND glue. So not sure if roofing felt will adhere properly.
Product here: http://www.toolstation.com/shop/Roofing ... 809/p73292
Can Black Jack products be thinned and if so, with what type of thinner?
Black Jack products should not be thinned unless labels expressly direct so. Thinning a product designed as ready-to-use can impact performance, and thinning certain products may violate government Volatile Organic Compound (VOC) regulations.Can I apply Black Jack coatings or cements if it will rain soon?
Yes. The products designed for wet weather application include:
Can I use this on rubber roofing?
Some rubber roofing materials require special cements and coatings manufactured for use on these materials alone. Check with the manufacturer if you are not sure.Can new built-up roofs be coated with aluminum coatings sooner than the recommended 90 to 180 days weathering period?
If an aluminum surface roof coating must be applied sooner to a new built-up roof, a water based emulsion coating should be used instead of a solvent-based asphalt coating. An emulsion coating will provide a firm base on which to apply the aluminum coating 5 to 10 days after the emulsion has cured.
How do I clean up a spilled Black Jack product?
Consult SDS data sheets for the specific products.How soon can I coat a newly installed built-up roof with an aluminum roof coating?
Black Jack Roof Felt Adhesive Instructions Home Depot
New asphalt built-up roof (BUR) surfaces should weather a minimum of 90 to 180 days prior to coating with Black Jack aluminum roof coatings.Black Jack Roof Felt Adhesive Instructions Mounting
